12/7/2023 0 Comments Raspberry pi samba shares![]() ![]() If you’re having trouble, make sure you rebooted after installing everything, otherwise you might not have the cifs kernel module loaded. To share files through Samba, see Server section to access files shared through Samba on other machines, please see Client section. Restart autofs so it finds the new config entries ⌗ sudo systemctl restart autofs Make sure the mount point exists sudo mkdir /mnt/data If you created a credentials file, it needs to look like this: username= ://server/share - you can put in an IP or hostname, and the share can be multiple folders deep.dir_mode / file_mode - default UNIX permissions for directories and files on the Windows share.I think the samba is up and running (connecting to the. noperm - ignore permissions for local users accessing the share There are tons of tutorials on setting up samba on the Raspberry Pi and I tried out quite a few.It might also be helpful to include the SMB configuration from the Raspberry Pis smb.conf file and the network configuration on the ASUS VivoBook S in the question, as this could provide more insight into the problem and allow for more targeted troubleshooting. credentials= - Alternative to putting the uname/password here, point to a file that has the credentials Other than that you could refer to the Samba Wiki on troubleshooting shares.password= - put the password here or use a dredentials file.username= - put the username here or use a credentials file.rw - enable read/write access to the share.-fstype=cifs - always needed for samba shares./mnt/data - the path on the local system to mount to.Not all of these options should be used all the time. timeout is how long to keep the shares mountedĪdd a new samba shares file and add a share to it ⌗Įdit the samba shares file we pointed to earlier sudo nano /etc/Īdd your new mount point /mnt/data -fstype=cifs,rw,username=,password=,credentials=,noperm,dir_mode=0777,file_mode=0777 ://server/share./etc/ is the file we will create to list our SMB shares How To Configure Samba To Share Directories On Raspberry Pi sudo nano /etc/samba/smb.conf A small Note from smb.conf: Add min protocol SMB2.all paths in the file are absolute, if you put /mnt here, then everything in would be mounted below /mnt) /- indicates that the following file should be mounted relative to / (i.e.sudo apt-get install autofsĪdd a samba shares file to the master autofs file ⌗Įdit the autofs master file: sudo nano /etc/auto.masterĪdd a line pointing to a (yet non existant) samba config file /- /etc/ -timeout 15 browse Often a good idea to reboot after doing things with apt. Install Autofs ⌗įirst you need the package. I tested this on Raspberry Pi OS (formerly Rasbian) Buster. Since I’ve always used fstab in the past to mount this, and it’s quite unreliable for cifs shares, and some internet articles go into way more detail than necessary on setting up autofs, here’s a very quick overview on setting up samba / CIFS shares with autofs on Raspberry Pi OS (or any other Debian / Ubuntu based system). I navigated to Settings>Services>SMB Client and noticed that Minimum protocol version was set to none and maximum set to SMBv1. As mentioned in my last blog post, I setup an autofs share to mount my NAS for backups. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |